Every metric below has its own screen. Start with the one you care most about, then connect the metrics together to understand why each shot behaved the way it did.
These metrics describe club delivery, ball flight, and distance outcomes for full-swing shots.
How fast the clubhead is moving just before impact.
Whether the club is traveling up or down at impact.
Loft presented at impact, not the loft stamped on the club.
Horizontal direction the club is moving through impact.
Where the face is pointing at impact relative to target.
Difference between face angle and club path.
Gap between delivered loft and direction of club travel.
Vertical tilt of the clubhead movement plane.
Horizontal orientation of the swing plane base.
Where the swing arc bottoms out relative to impact.
Vertical strike location on the clubface.
Horizontal strike location on the clubface.
Shaft lie orientation at impact.
How fast the ball leaves impact.
Efficiency ratio of ball speed to club speed.
Initial vertical launch of the ball.
How fast the ball is spinning after impact.
Initial horizontal start direction of the ball.
Tilt of the axis the ball rotates around.
Maximum ball-flight height.
Side movement from launch line to carry point.
How steeply the ball descends at landing level.
Distance traveled in the air.
Lateral offset at carry crossing point.
Estimated full distance including rollout.
Lateral offset at final resting position.
Radius of the measured swing arc segment.
Where downrange the ball reaches apex.
Vertical relation between impact position and no-interaction low point.
Horizontal relation between impact and modeled low point.
Tilt of the D plane relative to plumb line.
These metrics describe stroke mechanics, launch, skid and roll behavior, and green interaction.
Putter speed immediately before impact.
Time spent moving the putter away from the ball.
How far back the putter travels in backswing.
Time from transition to impact.
Backswing time divided by forward swing time.
Shaft lie at impact during putting stroke.
Putter face direction at impact.
Path direction of putter through impact.
Difference between putter face and path.
Up/down movement of putter at impact.
Initial left/right start direction of the putt.
Initial vertical launch of the putt.
Number of bounces in the skid phase.
Skid profile with constant deceleration and no bounce.
Initial ball speed off the putter face.
Distance from launch until true roll starts.
Ball speed when pure roll begins.
Percent speed loss from launch to roll start.
How much of total putt distance is true roll.
Distance to standardized entry-speed point.
Lateral offset from target at entry-speed point.
Straight-line distance traveled by the putt.
Putt-specific speed based on deceleration.
Estimated general green speed from deceleration.
Height change from start to entry-speed point.
Total sideways movement from launch line.
Average horizontal surface inclination.
Average vertical surface inclination.